|  |
|
| |  | | Material Safety Data Sheet
Product name: Elena’s Premier Latex Shine
01. Identification of the substance
Product name
Premier Latex Shine
Type
SILICONE OIL
02. Hazards identification
According to our data the product is not dangerous with respect to the German chemical law and the meaning of directive. 67/548/EEC.
Hazard designation
-
03. Composition/information on ingredients
None.
Hazardous components
-
04. First-aid measures
General
In all cases of doubt, or when symptoms persist, seek medical attention. Never give anything by mouth to an unconscious person. For
Further information refers to "specifications about toxicology".
After skin contact
Immediately remove all contaminated clothing. Wash away with soap and water and rinse.
After eye contact
Remove contact lenses, keep eyelids open. Flush with plenty of water (10 - 15 min.). Call a physician.
After ingestion
Drink plenty of water. Call a physician. Keep at rest.
05. Fire-fighting measures
Suitable extinguishing media
Alcohol resistant foam, CO2, powders, water spray.
Unsuitable extinguishing media
Water jet.
Special risk posed by the substance or by the actual preparation, its combustion products or
Gases discharged
In case of fire do not breathe fumes
Special protective equipment
No particular measures required.
Additional information
Cool endangered containers with water in case of fire.
06. Accidental release measures
Personal precautions
Refer to protective measures listed in sections 7 and 8.
Environmental precautions
If the product contaminates lakes, rivers or sewages, inform appropriate authorities in accordance with local regulations.
Methods for cleaning up/collecting
Remove mechanically, take-up residues with absorbing material. Wash away.
07. Handling and storage
Information for safe handling
Do not eat or drink during work - no smoking. Comply with the health and safety at work laws.
Requirements to be met by storerooms and containers
Containers should be kept dry and sealed.
1/3
Material Safety Data Sheet
Product name: Elena’s Premier Latex Shine
Information about separation of incompatible products
Keep away from oxidizing agents, from strongly alkaline and strongly acid materials.
Further information about storage conditions
Always keep in containers of same material as the original one. See also instructions on the label. Avoid heating and direct sunlight.
Storage class (VCI): 10
08. Exposure controls/personal protection
Additional information about engineering measures
No particular measures required.
Personal protective equipment
Respiratory protection
None but avoid breathing vapours if possible.
Eye protection
No particular measures required.
09. Physical and chemical properties
Relevant safety data
Physical state: liquid
Odour: Characteristic.
Colour: Colourless.
Boiling point / range: (1013 hPa) > 200 °C
Flash point: > 250 °C
Density: (20 °C) ca. 1 g/cm3
Solubility in water: (20 °C) inapplicable
Viscosity: (20 °C) 340 mPa.s
10. Stability and reactivity
Conditions to avoid
Stable under recommended storage and handling conditions (See section 7).
Materials to avoid
Keep away from oxidizing agents, strongly alkaline and strongly acid materials in order to avoid exothermic reactions.
Hazardous decomposition products
If this product is heated to > 150 degrees C, trace quantities of formaldehyde may be released, and adequate ventilation is required.
11. Toxicological information
There are no data available on the preparation itself. The product was classified in toxicological terms on the basis of the results of the
Calculation procedure outlined within General Directive on Preparations (1999/45/EC). This product is unlikely to harm health, given
Normal and proper handling and hygienic precautions.
Toxicological tests
LD50/LC50 values that is relevant for classification
Specification: LD-50
Routes of entry: oral
Test species: Rat
Value / dosage: > 5000 mg/kg
Specification: LD-50
Routes of entry: skin
Test species: Rat
Value / dosage: > 2008 mg/kg
Additional toxicological information
Product may emit formaldehyde vapour at temperatures above 150ºC in the presence of air. Formaldehyde vapour is a suspected
Carcinogen, toxic by inhalation and irritating to eyes and the respiratory system. Exposure limits should be strictly respected.
2/3
Material Safety Data Sheet
Product name: Elena’s Premier Latex Shine
12. Ecological information
Do not empty the product into drains and waters without primary treatment and do not store on public depositories.
13. Disposal considerations
In accordance with local official regulations.
14. Transport information
Land transport ADR/RID
Classification
Not subject to ADR/RID.
Class: -
Maritime transport IMDG/GGVSea
Classification
Not subject to IMDG code.
IMDG-Code: -
Air transport ICAO-TI and IATA-DGR
Classification
Not subject to IATA regulations.
Class: -
Additional transport information
None.
15. Regulatory information
According to our data the product is not dangerous with respect to the German chemical law and the meaning of directive. 67/548/EEC.
National regulatory information
Water pollution classification
Class: - according VwVwS
16. Other information
The details in this material safety data sheet satisfy national and EC legislation. We have no knowledge or control over the user´s
Working conditions however. The user is responsible for the observance of all required statutory provisions.
Further information
-
These data are based on our present knowledge. However, they shall not constitute a guarantee for any specific product features and
Shall not establish a legally valid contractual relationship.
~END~
3/ |
|
|
) 
